If you want to respond from your monitoring
phone, press
#1
using tone dialing.
You can turn off the baby monitor feature
by pressing
#0
.
Note:
R
The unit disconnects the call
automatically after 2 minutes.
Other programming
Changing the handset name
The default handset name is
“
Handset 1
”
to
“
Handset 6
”
. You can customize the name
of each handset (“Bob”, “Kitchen”, etc.). This is
useful when you make intercom calls between
handsets. To display the handset name in
standby mode, turn on the handset name
display feature (page 45).
1
M
MENU
N#104
2
Enter the desired name (10 characters
max.).
a
M
SAVE
N
a
M
OFF
N
Displaying the handset name
You can select whether or not the handset
name is displayed in standby mode. The
default setting is
“
Off
”
.
1
M
MENU
N#105
2
MbN
: Select the desired setting.
a
M
SAVE
N
a
M
OFF
N
Registering a unit
Operating additional units
Additional handsets
Up to 6 handsets can be registered to the
base unit.
Important:
R
See page 4 for information on the available
model.
Registering a handset to the
base unit
The supplied handset and base unit are
pre-registered. If for some reason the handset
is not registered to the base unit, re-register
the handset.
1
Handset:
M
MENU
N#130
2
Base unit:
Press and hold
M
LOCATOR
N
for about 5
seconds.
R
If all registered handsets start ringing,
press
M
LOCATOR
N
again to stop, then
repeat this step.
3
Handset:
Press
M
OK
N
, then wait until a long beep
sounds.
Deregistering a handset
A handset can cancel its own registration to
the base unit, or other handsets registered to
the same base unit. This allows the handset to
end its wireless connection with the system.
1
M
MENU
N#131
R
All handsets registered to the base unit
are displayed.
2
MbN
: Select the handset you want to
cancel.
a
M
SELECT
N
3
MbN
:
“
Yes
”
a
M
SELECT
N
a
M
OFF
N
For assistance, please visit http://shop.panasonic.com/support
45
Programming
TGD66x(en)_0420_ver020.pdf 45
2021/04/21 17:05:38
