Display message
Cause/solution
Main unit
no power
or
No link. Re-
connect base
AC adaptor.
R
Confirm the base unit’s AC adaptor is connected to
the unit and the power outlet correctly.
R
The handset has lost communication with the base
unit. Move closer to the base unit and try again.
R
Unplug the base unit’s AC adaptor to reset the unit.
Reconnect the adaptor and try again.
R
The handset’s registration may have been canceled.
Re-register the handset (page 41).
Requires
subscription
to Caller ID.
R
You must subscribe to a Caller ID service. Once you
receive caller information after subscribing to a Caller
ID service, this message will not be displayed.
Use
rechargeable
battery.
R
A wrong type of battery such as alkaline or
manganese was inserted. Use only the rechargeable
Ni-MH batteries noted on page 4, 8.
Troubleshooting
If you still have difficulties after following the instructions in this section, disconnect the base unit’s
AC adaptor, then reconnect the base unit’s AC adaptor. Remove the batteries from the handset,
and then insert them into the handset again.
General use
Problem
Cause/solution
The handset does not turn on
even after installing charged
batteries.
R
Place the handset on the base unit or charger to turn on
the handset.
The unit does not work.
R
Make sure the batteries are installed correctly (page 11).
R
Fully charge the batteries (page 12).
R
Check the connections (page 11).
R
Unplug the base unit’s AC adaptor to reset the unit.
Reconnect the adaptor and try again.
R
The handset has not been registered to the base unit.
Register the handset (page 41).
For assistance, please visit http://shop.panasonic.com/support
61
Useful Information
TGD56x(en)_1121_ver021.pdf 61
2016/11/21 17:27:41
