R
The following are used for both uppercase and lowercase:
Cyrillic character table (
)
z
y
1 2 3 4 5 6 7 8 9
Error messages
Display message
Cause/solution
Base no power
or
No link.
Reconnect
AC adaptor.
or
No link.
R
Confirm the base unit’s AC adaptor is connected to the unit
and the power outlet correctly.
R
The handset has lost communication with the base unit. Move
closer to the base unit and try again.
R
Unplug the base unit’s AC adaptor to reset the unit.
Reconnect the adaptor and try again.
R
The handset’s registration may have been cancelled.
Re-register the handset (page 34).
R
When
“
No link.
”
is displayed during a power failure, place
a handset on the base unit to supply power to the base unit.
Check
Phone Line
R
The supplied telephone line cord has not been connected yet
or not connected properly. Check the connections (page 9).
Error
R
Recording was too short. Try again.
Memory Full
R
The phonebook memory is full. Erase unwanted entries
(page 20).
R
The call block list memory is full. Erase unwanted entries
(page 30).
R
The maximum number of base units (4) is already registered
to the handset. Cancel unused base unit registrations from
the handset (page 34).
Use
rechargeable
battery.
R
A wrong type of battery such as alkaline or manganese was
inserted. Use only the rechargeable Ni-MH batteries noted on
page 4, 6.
You must first
subscribe
to Caller ID.
R
You must subscribe to a Caller ID service. Once you receive
caller information after subscribing to a Caller ID service, this
message will not be displayed.
47
Useful Information
0303_TGD3xxNZ(en-en)_ver002.pdf 47
2015/03/03 10:28:06
