Changing the base unit PIN
(Personal Identification Number)
Important:
R
If you change the PIN, please make note of
your new PIN. The unit will not reveal the
PIN to you. If you forget your PIN, contact
an authorised service centre.
1
(middle soft key)
#132
2
Enter the current 4-digit base unit PIN
(default:
“
0000
”
).
3
Enter the new 4-digit base unit PIN.
a
a
M
N
Registering a unit
Operating additional units
Additional handsets
Up to 6 handsets can be registered to the
base unit.
Important:
R
The additional handset model
recommended for use with this unit is noted
on page 4. If another handset model is
used, certain operations (handset settings,
base unit settings, etc.) may not be
available.
Registering a handset to the
base unit
The supplied handset and base unit are
pre-registered. If for some reason the handset
is not registered to the base unit (for example,
is displayed even when the handset is
near the base unit), re-register the handset.
1
Handset:
(middle soft key)
#130
2
Base unit:
Press and hold
M
N
for about 5 seconds,
until the registration tone sounds.
R
If all registered handsets start ringing,
press
M
N
again to stop, then repeat
this step.
R
The next step must be completed
within 90 seconds.
3
Handset:
a
Wait until
“
Base PIN
”
is
displayed.
a
Enter the base unit PIN
(default:
“
0000
”
).
a
R
If you forget your PIN, contact an
authorised service centre.
R
When the handset has been registered
successfully,
is displayed.
Note:
R
While registering,
“
Base in
registering
”
is displayed on all
registered handsets.
R
When you purchase an additional handset,
refer to the additional handset’s installation
manual for registration.
Deregistering a handset
A handset can cancel its own registration to
the base unit, or other handsets registered to
the same base unit. This allows the handset to
end its wireless connection with the system.
1
(middle soft key)
#131
R
All handsets registered to the base unit
are displayed.
2
MbN
: Select the handset you want to
cancel.
a
3
MbN
:
“
Yes
”
a
R
A confirmation tone sounds.
R
The handset does not beep when
cancelling its own registration.
4
M
N
One touch eco mode
If you want to activate eco mode, set the
repeater mode
“
Off
”
beforehand (page 44).
The
M
ECO/R
N
button on the handset enables
you to activate the eco function with one touch.
By activating eco mode, your unit can reduce
the base unit transmission power by up to
90% in standby mode.
30
Programming
TG80xxAL_NZ(en)_1021_ver001-2.pd30 30
2011/10/21 15:09:43
