Useful Information
35
Helpline Tel. No.: U.K. 08700 100 076 R.O.I. 01289 8333
The handset/base unit stops
working while being used.
L
Disconnect the AC adaptor and turn off the
handset. Connect the AC adaptor, turn on the
handset and try again.
Pressing
{R}
does not
display/dial the last number dialled.
L
The redialled number was more than 24 digits long.
Redial the number manually.
The handset beeps intermittently
and/or
7
flashes.
L
Fully charge the batteries (page 10).
I fully charged the batteries, but
7
still flashes.
L
Clean the charge contacts and charge again (page
10).
L
It is time to replace the batteries (page 9).
Caller information is not displayed.
L
You must subscribe to Caller ID service.
L
Your unit is connected to a telephone line with DSL
service. We recommend connecting a filter (contact
your DSL service provider) to the telephone line
between the base unit and the telephone line jack.
While viewing caller information,
the display returns to standby
mode.
L
Do not pause for over 1 minute while searching.
I cannot register a handset to the
base unit.
L
The maximum number of handsets (6) are already
registered to the base unit. Cancel unused handset
registrations from the base unit (page 29).
L
You entered the wrong PIN number. If you forget
your PIN, see “I cannot remember the PIN.” (page
35).
L
Place the handset and the base unit away from
other electrical appliances.
I cannot remember the PIN.
L
Change the PIN using the following method.
1
{j
/OK
}
2
Press
{^}
or
{V}
to select
“
Base Unit
Setup
”
.
i
{
>
}
3
“
Other Options
”
i
{
>
}
4
“
Base Unit PIN
”
i
{
>
}
5
Press
{*}{
7
}{
0
}{
0
}{
0
}
.
6
Enter the new 4-digit base unit PIN.
i
{
>
}
i
{ih}
Problem
Cause & solution
TG7100-7120E(e).book Page 35 Tuesday, July 4, 2006 3:29 PM
