Panasonic KX-TG1061M - Cordless Phone Base Station, Service Manual, Page: 51 / 114

51
KX-TG1061M/KX-TG1062M/KX-TGA106M
9.2. Troubleshooting by Symptom (Base Unit and Charger Unit)
If your unit has below symptoms, follow the instructions in remedy column. Remedies depend on wether you have DECT tester
(*1) or not.
Note:
(*1) A general repair is possible even if you don’t have the DECT tester because it is for confirming the levels, such as Acoustic
level in detail.
(*2) Refer to
Check Point (Base Unit) (P.51)
9.2.1. Check Point (Base Unit)
Please follow the items below when BBIC, EEPROM or FLASH is replaced.
Note:
After the measuring, suck up the solder of TP.
*:
How to install Batch file into P.C. (P.66) is required beforehand.
The connections of simulator equipments are as shown in Adjustment Standard (Base Unit) (P.67).
Items Check
Point
Procedure Check or
Replace Parts
( A ) 3.5 V Supply Confirma-
tion
VDD3 1. Confirm that the voltage between test point VDD3 and GND is 3.5 V ± 0.2 V. IC301,R311,
R312,C311,
D301,F301
( B ) 3.75 V Supply Confirma-
tion
VDD5 1. Confirm that the voltage between test point VDD5 and GND is 3.75 V ± 0.2 V. IC304,R384,
R385,C385,
D301,F301
( C ) 2.5 V Supply Confirma-
tion
VDD2 1. Confirm that the voltage between test point VDD2 and GND is 2.5 V ± 0.2 V. D311,IC303
( D ) 3.0 V Supply Confirma-
tion
VDD4 1. Confirm that the voltage between test point VDD4 and GND is 3 V ± 0.2 V. C504,R387,
IC501
( E ) 1.8 V Supply Confirma-
tion
VDD1 1. Confirm that the voltage between test point VDD1 and GND is 1.8 V ± 0.1 V. Q351,IC501
( F )* BBIC Confirmation - 1. BBIC Confirmation (Execute the command “getchk”).
2. Confirm the returned checksum value.
Connection of checksum value and program number is shown below.
IC501
( G )* EEPROM Confirmation - 1. EEPROM Confirmation (Execute the command “sendchar EPV”).
2. Confirm the returned value.
(Value for reference is written at”EEPROM C/SUM” in
Software_Version_Table.xls)
Note:
“checksum” vary depending on the country version. You can find them in the
batch file, PNZZ- mentioned in
The Setting Method of JIG (Base Unit) (P.65).
IC561
( H )* BBIC Clock Adjustment CLK
GND_C
1. Check X’tal Frequency. (10.368 MHz ± 100 Hz).
Input Command “sendchar sfr”, then you can confirm the current value.
2. If the frequency is not 10.368 MHz ± 100 Hz, Adjust the frequency of CLK exe-
cuting the command “sendchar sfr XX YY (where XX YY is the value)” so that
the reading of the frequency counter is 10.368000 MHz ± 20 Hz.
IC501,X511