Panasonic KX-TDE200, Installation Manual

Page: 179 / 204

Quick Setup, you will set up the basic items. For details about the basic items, refer to "2.3.4 Quick Setup" in
the Feature Guide.
1. Connect the PC to the PBX with an Ethernet straight cable or RS-232C cross cable.
2. Start the Maintenance Console from the Start menu.
3. "Information before programming" appears.
a.
Carefully read this important additional information, which includes updates to this and other
manuals.
b.
Click OK to close this window.
4. a.
Enter the Installer Level Programmer Code (default: INSTALLER ).
Note
There are 2 other Programmer Codes with limited authorisation: Administrator Level (default:
ADMIN ), and User Level (default: USER ).
b.
Click OK .
5. Click Connect .
6. a.
Select KX-TDE100/200 from PBX Model .
b.
Select the LAN or RS-232C tab, depending on the type of PC connection with the PBX.
c.
Specify the settings as required.
Note
When connecting to the PBX for the first time selecting LAN , the IP Address and Port
Number must be set to 192.168.0.101 and 35300 respectively.
d.
Enter the system password for installer (default: 1234 ).
e.
Click Connect .
7. When country/area data do not match:
a.
Click OK to replace the country/area data of the PBX. Replacement may take several minutes
to complete.
b.
Follow the procedure described in "3.13.1 Starting the PBX" and restart the PBX.
c.
Repeat step 5 to reconnect the Maintenance Console to the PBX.
8. Follow the instructions of the Quick Setup wizard and assign the basic items (Quick Setup).
After Quick Setup is completed, if the IP addressing information was not changed and a V-IPEXT
card was installed during setup, the IP-PT registration screen is displayed. For information on
registering IP-PTs to the PBX, refer to "3.15 [1-1] Slot—Port Property - Virtual IP Extension" in the
PC Programming Manual. You may now begin programming the PBX.
Notice
1.
During a long programming session, it is highly recommended that you periodically save the system
data to the SD Memory Card. If the PBX undergoes a sudden power failure or if the system is reset for
some reason, all the system data in RAM will be lost. However, if system data has been saved to the
SD Memory Card, it can be easily restored.
To save the system data to the SD Memory Card, (1) click the "
SD Memory Backup " icon before
resetting the PBX or turning off the power, or (2) exit the Maintenance Console so that the PBX
automatically saves the system data.
2.
The PC will not perform any shutdown operation, or enter the power-saving system standby mode
while the Maintenance Console is connected to the PBX. To perform either of the operations above,
first close the connection to the PBX.
Installation Manual 179
4.3.1 Installing and Starting the Maintenance Console