Panasonic KX-TD816, Programming Manual, Page: 291 / 443

3.2 System Programming
ISDN Programming 291
Display: 109 EXPAND C,E1
2.
Press NEXT to programme the Master System.
To programme "Slave", press NEXT again.
Display example: Master:C ;E1;E2
3.
Keep pressing SELECT until the desired selection in Area 1 is displayed.
4.
Press to programme another Area, if required.
5.
Keep pressing SELECT until the desired selection in the Area is displayed.
6.
Repeat steps 4 and 5 until all the required entries are completed.
7.
Press STORE.
If only one system is in operation, go to step 10.
8.
Press NEXT to programme the Slave System.
Display example: Slave :C ;E1;E2
9.
Repeat steps 3 through 7, if required.
10.
Press END.
Conditions
• The following units can be installed in the slots.
– C (4-CO lines): KX-TD180
– S2 (2-ISDN S0 lines): KX-TD280
– S6 (6-ISDN S0 lines): KX-TD286
– PR (1-PRI ISDN line): KX-TD290
– BD (4-DID lines with Pulse/DTMF): KX-TD185
– MD (4-DID lines with MFC): KX-TD185
– EM (4-E&M lines): KX-TD184
– EL (1-E1 line): KX-TD188
– E, E1, E2 (8-Extension lines): KX-TD170
– A, A1, A2 (16-SLT lines): KX-TD174
• There are two expansion areas in the KX-TD816, areas 1 and 2 from bottom to top. One
extension line unit and one outside line (CO / ISDN S0 / DID / E&M) unit can be installed.
• There are three expansion areas in each system for the KX-TD1232, areas 1, 2 and 3 from
bottom to top. Up to two extension line units and one outside line (CO / ISDN S0 / E1 / DID
/ E&M) unit can be installed.
• The KX-TD188 and KX-TD290 can only be installed to the KX-TD1232 Master system.
In this case, the basic and extended outside line in the Slave system cannot be used.
• If the KX-TD290 is installed to the KX-TD1232 Master system, the KX-TD280 or KX-
TD286 can be installed to the Slave system only to use the ISDN extension lines.
• An out-of-service system is unassignable. In this case, skip steps 8 and 9 for the KX-
TD1232.
• For the KX-TD1232, if only the Slave system is in operation, the display shows "Slave" in
step 2.
• After changing the setting, turn the Power Switch off and on once. Otherwise, the previous
setting will remain.