Panasonic KX-TCA151AZV, Service Manual

Page: 49 / 137

2. Change a directory.
3. Type “SET_COM 1” from the keyboard (when COM port 1 is used
for the connection).
4. Type “doskey”.
Note:
See the table below for frequently used commands.
Command name Function Example
rdeeprom Read the data of EEPROM Type “rdeeprom 00 00 FF”, and the data
from address “00 00” to “FF” is read out.
readid Read ID (RFPI) Type “readid”, and the registered ID is
read out.
writeid Write ID (RFPI) Type “writeid 00 18 E0 0E 98”, and the
ID “0018 E0 0E 98” is written.
setfreq adjust Frequency of RFIC Type “setfreq nn”.
hookoff off-hook mode on Base Type “hookoff”.
hookon on-hook mode on Base Type “hookon”.
Getchk Read checksum Type “getchk”.
Wreeprom write eeprom Type "wreeprom 01 23 45". "01 23" is
address and "45" is data to be written.
13. CHECK PROCEDURE (HANDSET)
13.1. Preparation
13.1.1. Equipment Required
- DECT tester: Rohde & Schwarz, CMD 60 is recommended.
- Frequency counter: it must be precise to be able to measure 1Hz
(precision; ± 4ppm).
Hewlett Packard, 53131A is recommended.
- DC power: it must be able to output at least 1A current under 2.4V
for Handset, 9V for JIG.
- Digital multi-meter (DMM): it must be able to measure voltage and
current.
- Oscilloscope
13.1.2. JIG and PC
- EEPROM serial JIG
JIG Cable: PQZZ1CD505E
49