Panasonic KX-NCP500, Getting Started, Page: 23 / 64

When using a DHCP server: a.
Select Enable for the DHCP Client setting.
b.
Click Apply .
Note
The boxes will turn grey and the IP addresses will be
assigned automatically after the PBX is reset.
When not using a DHCP server: a.
Select Disable for the DHCP Client setting.
b.
In the IP Address for IPCMPR Card box, type the IP
address of the IPCMPR card.
*1
c.
In the IP Address for VoIP-DSP box, type the IP
address of the DSP card.
*2
d.
In the Subnet Mask box, type the subnet mask
address of the network.
*3
e.
In the Default Gateway box, type the IP address of
the default gateway.
*4
f.
Click Apply .
After Quick Setup is completed, if the IP addressing information was not changed, the IP-PT registration
screen is displayed. For information on registering IP-PTs to the PBX, refer to "Registration of
IP-PTs" in "4.3.2 Registering IP Telephones".
Notice
•
Do not change the IP addresses of the IPCMPR and DSP cards once IP telephones are registered to
the PBX using these IP addresses.
The IP telephones will not operate properly if these IP addresses are changed.
•
A DHCP server must be able to use a "client identifier" option specified by RFC 2131.
•
The PBX will not start properly if the IP addresses cannot be assigned automatically by the DHCP
server when DHCP Client is set to Enable. In this case, you need to consult your network administrator
because the DHCP server on your network may not be running or a network failure may have occurred.
If the DHCP server is not available, change the DHCP Client setting to Disable and set fixed IP
addresses, then restart the PBX.
To change the DHCP Client setting, connect the PC with an RS-232C cross cable or Ethernet straight
cable. When connecting the PC with an Ethernet straight cable, make sure the PBX is disconnected
from the LAN and then connect the PC with an Ethernet straight cable using 192.168.0.101 for the IP
address of the IPCMPR card.
*1 Valid IP address range: "1.0.0.0" to "223.255.255.255"
*2
Valid IP address range: "1.0.0.0" to "223.255.255.255"
*3 Valid subnet mask address range: "0–255.0–255.0–255.0–255" (except 0.0.0.0 and 255.255.255.255)
*4 Valid IP address range: "1.0.0.0" to "223.255.255.255"
Getting Started 23
4.1.1 Starting the Maintenance Console and Assigning the Basic Items (Quick Setup)