Screen / Tab
Setting item
Description
Input Type
Note
1.Port-Analog -
Dialing
Pulse Speed
Selects the speed at which
pulse dials are sent to the
analog trunk.
Select
DTMF Width
Selects the length of the DTMF
tone sent to the analog trunk.
Select
Disconnect Time
Specifies the length of time
after a trunk is disconnected,
during which the PBX cannot
seize the line.
Select
1.Port-Analog -
Caller ID
Caller ID(FSK) -
Carrier Detection
Enables the PBX to detect the
carrier when receiving Caller
ID.
Radio
Caller ID(FSK) - END
Detection
Selects the method used to
detect the end of Caller ID
information.
Radio
Caller ID(FSK) -
Header Examination
Enables the PBX to check the
header of received Caller ID
information.
Radio
Caller ID(FSK) -
Detection Start Timer
Specifies the length of time
that the PBX waits before
attempting to detect Caller ID
information, after receiving a
call. To enable this setting,
Caller ID Detection Pattern
should be set to FSK.
Select
Caller ID(FSK) -
Detection Timer
Specifies the total time
required by the PBX to detect
Caller ID information.
Select
Caller ID(DTMF) -
Start Code 1
Selects the DTMF code used
to detect the beginning of a
Caller ID series.
Select
Caller ID(DTMF) -
Start Code 2
Selects the DTMF code used
to detect the beginning of a
Caller ID series.
Select
Caller ID(DTMF) -
Information Start Code
Selects the DTMF code used
to detect the beginning of the
information segment of a Caller
ID series.
Select
Caller ID(DTMF) - End
Code
Selects the DTMF code used
to detect the end of a Caller ID
series.
Select
Caller ID Header[03]
Selects the type of the 3rd
header in a Caller ID signal.
Radio
2.4.1 PBX Configuration—[3-1] Trunk—Port
Programming Item List
39
