Securing with screws
Important:
R
Make sure the screws are shorter
than the thickness of the installation
surface.
1
Remove the sensor from the
mounting adaptor by pressing the
release lever (
A
), sliding the
sensor up and lifting it away from
the mounting adaptor (
B
).
A
B
2
Use the screws to attach the
mounting adaptor to the inside of
the garage door.
R
Make sure the “
UP
” mark on
the mounting adaptor points
upwards when the garage door
is closed.
UP
UP
A
25.4 mm (1 inch)
3
Attach the sensor to the mounting
adaptor.
R
The sensor will click into place
when it is secured.
R
Make sure the “
UP
” marks on
the back of the sensor and the
inside of the mounting adaptor
point in the same direction.
For assistance, visit www.panasonic.ca/english/support
15
Setup
HNS107C_(en_en)_0212_ver.011.pdf 15
2016/02/12 9:35:26