Part names and
functions
TEMP
A
C
D
E
B
On/off switch
LED indicator
Motion sensor
Maintenance button
Press this button to disable the
switch while replacing light bulbs.
When finished, press the button
again.
M
N
Used to confirm the status of the
switch or register the switch to the
hub.
LED indicator
During normal operation, the LED
indicator lights in blue when the
surrounding environment is dark,
allowing you to use the LED indicator
as a night light.
You can also press
M
N
and check
the LED indicator to confirm the
switch’s status.
Indicator
Status
Off
Switch is off, no power
supplied to switch
Green, lit
Switch is on
Green,
blinking
slowly
Registration mode
(You pressed and held
M
N
)
Red,
blinking
very quickly
Motion was detected
Red,
blinking
Switch is out of range
of the hub
Note:
R
The LED indicator does not indicate
the status of the switch if the switch
has not been registered to a hub
(page 11).
Setup overview
1
Initial setup
Make sure you can access the
system using your mobile device.
For details, refer to the System
Setup Guide included with your
hub.
2
Confirm the installation
conditions
Read the information in this
document to confirm that the
installation conditions are suitable
to proper operation.
3
Installation
Install the switch in the desired
location.
4
Registration
Required only if the switch was
purchased separately (i.e., not as
part of a bundle).
For assistance, please visit http://shop.panasonic.com/support
7
Setup
Summary of Contents for KX-HNL200
Page 19: ...19 Notes ...
