6
(Model KX-FP320E/KX-FM330E)
KX-FP320E/KX-FM330E
2. Sometimes there is a transmit problem (Change from original page 46)
TX Problem
Is the document pre-fed?
Is auto dialing used to
send?
Did you press the START
key immediately after
dialing?
Decrease the TX
level from -11
dBm to - 15
dBm or same
value.
Check the other party's
machine. (Out of paper,
auto answer off, etc.)
Check the current TX level.
Change the "594: Oversea
DIS detection" to "Detect
at the 2nd time".
Confirm that "592:CNG TX
select" is set to "ALL".
Does TX start?
(Does it start feeding?)
Increase the "596:Transmit
level set" from -11 dBm
to -5 dBm or same value.
The document goes
through.
Ask the other party to
change the RX equalizer &
increase the TX level.
Ask the other party to
increase the TX level.
Ask the RX party to
increase the parameter of
the RX error line value to
more than the current
setting.
(Not available)
Confirm if the sent image
on the RX side has many
errors.
Change the "717:Transmit
speed select " to
7200,4800 or 2400 bps.
• Increase the "596:Transmit
level set" from -11 dBm
to -5 dBm or some value.
OR
• Decrease the "596:Trans-
mit level set" from -11
dBm to -13 dBm .
Try again.
• Decrease the "596: Trans-
mit level set" from -11 dBm
to -15 dBm.
Try again.
YES
YES
YES
YES
NO
NO
NO
NO
NG
NG
NG
OK
OK
OK
"Transmit Error"
Message on LCD
12000,9600
Note:
“596: Transmit level set” represents a service code. (Refer to 2.4.4. Service Function Table.)
Refer to the Service Function Table.
