Panasonic KX-FC379CX, Service Manual

Page: 77 / 250

Code Function Set Value Default Remote
Setting
570 Break % select 1:61% / 2:67% 61% OK
571 ITS auto redial time set 00~99 00 OK
572 ITS auto redial line disconnection time set 001~999sec 065sec OK
573 Remote turn-on ring number 01~99 10 OK
580 TAM continuous tone detection 1:ON / 2:OFF ON OK
590 FAX auto redial time set 00~99 05 OK
591 FAX auto redial line disconnection time set 001~999sec 065sec OK
592 CNG transmit select 1:OFF / 2:ALL / 3:AUTO ALL OK
593 Time between CED and 300 bps 1:75ms / 2:500ms / 3:1sec 75ms OK
594 Overseas DIS detection 1:1st / 2:2nd 1st OK
595 Receive error limit value 001~999 100 OK
596 Transmit level set -15~00dBm -10dBm OK
598 Receiving Sensitivity 20~48 40 OK
710 Memory clear except History data --------- --------- NG
717 Transmit speed select 1:14400 / 2:12000 / 3:9600/ 4:7200/
5:4800/ 6:2400 14400bps OK
718 Receive speed select 1:14400 / 2:12000 / 3:9600/ 4:7200/
5:4800/ 6:2400 14400bps OK
722 Redial tone detect 1:ON / 2:OFF OFF OK
731 CPC mode 1:A / 2:B / 3:OFF A OK
732 Auto disconnect 1:350ms / 2:1800ms / 3:OFF 350msec OK
745 Power on film feed 1:ON / 2:OFF ON OK
763 CNG detect time for friendly reception 1:10s / 2:20s / 3:30s 30s OK
771 T1 timer 1:60s / 2:90s 60s OK
774 T4 timer 00~99 x 100ms 00ms OK
775 Monitoring of message transfer 1:ON / 2:OFF OFF OK
784 Voice prompt 1:Start --------- NG
815 Sensor & VOX test --------- --------- NG
841 Digital SP-Phone RX & TX check 1:SP-Phone --------- NG
852 Print test pattern --------- --------- NG
853 Top margin 1~9 5 OK
874 DTMF ON time 060~200 × msec 180 ms OK
875 DTMF OFF time 060~200 × msec 090 ms OK
880 History list 1:Start --------- NG
881 Journal 2 1:Start --------- NG
882 Journal 3 1:Start --------- NG
958 Cordless test mode --------- --------- NG
991 Setup list 1:Start --------- OK
994 Journal list 1:Start --------- OK
995 Journal 2 list 1:Start --------- OK
996 Journal 3 list 1:Start --------- OK
998 History list 1:Start --------- OK
999 Service list 1:Start --------- OK
OK means "can set".
NG means "can not set".
Note:
Refer to Service Function Table (P.56) for descriptions of the individual codes.
Example:
If you want to set value in the "004 Transmission report mode", press the dial key number 1,2 or 3 corresponding to the Set
Value you want to select. (1:ERROR/2:ON/3:OFF)
76
KX-FC379CX