D&N Sensitivity
It is to set sensitivity to change to Day mode and to Night
mode. You can select High, Middle or Low, the default is
Middle.
D&N Delay
It is to set delay time before change to Day mode and to Night
mode.
BLC Mode
BLC
The device auto exposures according to the
environments situation so that the darkest area
of the video is cleared
WDR
For the WDR scene, this function can lower the
high bright section and enhance the brightness
of the low bright section. So that you can view
these two sections clearly at the same time.
The value ranges from 1 to 100. When you
switch the camera from no-WDR mode to the
WDR mode, system may lose several seconds
record video.
HLC
After you enabled HLC function, the device can
lower the brightness of the brightest section
according to the HLC control level. It can reduce
the area of the halo and lower the brightness of
the whole video.
The value ranges from 1 to 100. The default
value is 50 when HLC is on.
HLC is enabled only when anti-flicker is outdoor
and exposure mode is auto.
OFF
It is to disable the BLC function. Please note this
function is disabled by default.
Mirror
It is to switch video left and right limit.
This function is disabled by default.
Flip
It is to switch video up and bottom limit. This function is
disabled by default. The video resolution shall be 720P or
below if you want to flip 90°.
DNR
It is to switch digital noise reduction on and off.
DNR Level
It is to set digital noise reduction level. The value ranges from 1
to 100. The default value is 50.
Cancel
It is to cancel the operation in current interface and restore
previously saved operation.
Default
It is to set device default setup.
27
Summary of Contents for K-EF134L01E
Page 9: ...Figure 2 5 6 ...
Page 24: ...Figure 3 6 Figure 3 7 1 21 ...
Page 51: ...See Figure 3 24 Figure 3 24 See Figure 3 25 48 ...
