Panasonic JS-950 Series, User Manual

Page: 18 / 239

18
■
Rear Display Block Installation
1. How to mount the rear display block
(1) Loosen the thumbscrew on the lower portion of the rear cover at the rear display side of the
main block by hand, and remove the rear cover.
* The thumbscrew shall be loosened until the screw rotates without resistance.
(2) Prepare a rear display to be used. (The contents here explain the 2-line type.)
(3) Connect the hook of the rear display to the hole of the main block, and tighten the 2
thumbscrews by hand to secure it.
(4) Connect the connector of the rear display with the connector of the main block.
* The cable shall be clamped to prevent the cable from coming out from the main block.
(5) Be care that the cable doesn't protrude beyond the case.
In case of installation of 2 line Rear Display module, clump the cable as shown in the fig.
(5)-1. In case of installation of 4 line Rear Display module, you do not need clump cable.
(6) Peel off the blind seal attached on the window of the rear cover.
(7) Attach the rear cover on the main block, and tighten the thumbscrew on the lower portion
by hand to secure the cover.
Be sure to disconnect the power cable of the main block (POS Workstation) and confirm
the power is “OFF” before the operation below.
(4) １
(1)-1
(1)-2
(2)
(5)-2
(5)-1
(7)
(3)-2 (4)
(3)-1