13.5.1 Configure the settings relating to TCP alarm notification
TCP alarm notification
[TCP alarm notification]
Select “On” or “Off” to determine whether or not to provide notification by TCP alarm notification according to
the settings for the “Alarm” and “Diag.” checkboxes of “Destination of notification” below.
–
When an alarm is detected (“Alarm”)
–
When a notification of the remaining capacity of the SD memory card has been provided (“Diag.”)
–
When the SD memory card has become full (“Diag.”)
–
When the SD memory card cannot be recognized (“Diag.”)
•
Default:
Off
Note
•
When “On” is selected, notification of the alarm occurrence will be provided to the registered destination
server addresses in order (to IP address 1 first, to IP address 8 last).
118
Operating Instructions
13 Configure the alarm settings [Alarm]