Registering the
camera to your hub
Do not perform this procedure if
you are using the camera by
itself (i.e., you do not have a
KX-HNB600 hub). Use the initial
setup procedure (page 19).
If you want to integrate your HD
camera with a Panasonic Home
Network System, you must
register the camera to the hub.
Registering the camera
Confirm the following before you
begin.
– Make sure you can use your
mobile device to access the hub
– Make sure the hub’s firmware is
up to date and that you are
using the latest version of the
[Home Network]
app.
For more information, refer to
the System Setup Guide
included with your hub and the
User’s Guide (page 31).
1
Plug in the camera and wait
about 1 minute for the
camera’s LED to light in green.
R
If the LED does not light in
green, or if you experience
trouble during this
procedure, reset the
camera (page 25) and
then repeat this procedure.
2
Start the
[Home Network]
app.
3
From the
[Home Network]
app home screen, tap
[Settings]
.
4
Tap
[Device Registration]
®
[Registration]
®
[HD
Camera]
®
[Method 1]
.
5
When prompted, press the
M
SETUP
N
button on the back
of the camera.
R
The camera registers your
mobile device.
R
The app’s home screen is
displayed when registration
is complete.
6
Follow the on-screen
instructions. When prompted,
set the password that will be
used to access the camera.
Note:
R
When registration is complete,
the hub sounds one long beep.
R
If registration fails, the hub
sounds several short beeps.
24
For assistance, please visit http://shop.panasonic.com/support
Setup
HNC800_(en_en)_0902_ver.220.pdf 24
2016/09/05 17:54:31
