3
Insert an anchor, tighten the screw, then
remove the screw to secure the anchor.
4
Insert the screw and tighten it.
2
2
Wall mounting adaptor
ALC (autoclaved lightweight cellular
concrete)
R
Depending on the type of ALC panel, you
may not be able to attach the camera.
Consult the ALC panel manufacturer.
R
Do not use the included screws. After
consulting the manufacturer of the ALC
panel, use only commercially-available
metal screw anchors (screw ø4 mm
(
5
/
32
inches)) designed for ALC panels.
R
Carefully read the instructions supplied with
the anchors. Follow instructions regarding
drill bit diameter, hole depth, etc.
R
Drill a pilot hole. Remove any debris after
drilling the pilot hole.
R
Seal the pilot hole with a
commercially-available waterproof sealant.
Other materials (mortar, tile, etc.)
R
Do not use the included screws.
R
Consult the builder or licensed professional
regarding the type of anchor appropriate for
the installation location and materials.
R
Do not install on gypsum board or concrete
blocks.
Installing the front door camera
1
Attach the wall mounting adaptor to a
porch wall.
R
Secure the wall mounting adaptor to
the wall by tightening the 3 supplied
screws (
A
).
R
The spacer can be used to adjust the
installation angle of the camera as
necessary (“Using the spacer”,
page 27).
R
Do not attach the wall mounting
adaptor at an angle or vertically. (This
will result in the sensors being unable
to correctly make detections.)
2
Slide the lock key of the interface cover
on the bottom of the camera (
B
).
3
Open the interface cover (
C
).
4
Slide the power slide switch to ON (
D
).
1
1
1
4
3
2
26
For assistance, visit www.panasonic.ca/english/support
Setup
HN7051C_(en_en)_0319_ver.040.pdf 26
2018/03/19 19:00:12