Camera LED indicators
You can use the LED indicators to confirm the camera’s status.
Camera LED indicator
Status
Off
R
No power
R
More than 5 seconds have passed since turning on the
power when the camera is not registered to the access
point
R
LED indicator is turned off
Green or amber, blinking quickly -
off for 1 second
Camera is on
Amber, lit
Not registered to the access point
, or signal level is
good
Green, lit
Registration successfully completed or signal level is
strong
Green, blinking quickly
Camera is searching for an access point
Red, lit
Registration failed, signal level is weak
, or detecting
motion
Red, blinking quickly
Streaming data
Amber, blinking slowly
Battery is running low
Green, blinking slowly
Registration mode, updating
Red, blinking slowly
Camera is out of range of the access point
,
*1 You can configure the camera so that its LED indicator does not light during normal
operation. For more information, refer to the User’s Guide (page 31).
*2 The LED indicator lights in amber for 5 seconds after the power is turned on for the camera.
*3 The signal level (strong, good, weak, out of range) is shown after pressing
M
SETUP
N
for 3
seconds.
20
For assistance, visit www.panasonic.ca/english/support
Setup
HN7051C_(en_en)_0319_ver.040.pdf 20
2018/03/19 19:00:12
