14
Parts and their functions
<Rear panel>
<Bottom panel>
1
Remote controller signal receiver
Light sensors are located in two places at the front of the
camera pedestal.
These sensors are used when the IR repeater function
(page 13) is used.
2
Status display lamp
This lights in the following way depending on the status of
the unit.
Orange: Standby mode (page 18)
Green: Power ON mode (page 18)
Red:
When trouble has occurred in the unit
Green and blinks twice:
When signals from the remote controller are
received
3
Camera head
This rotates in the horizontal direction.
4
Lens unit
This rotates in the up and down direction.
5
HDMI connector [HDMI]
This is the HDMI video output connector.
6
IR system/service connector [IR/SERVICE]
Connect the IR system cable to this connector. (See
page 16.) The connector is also used for maintenance
purposes.
7
Anti-theft wire mounting hole
Use this hole to attach the wire bracket.
8
DC IN connector [16V IN
]
Connect the AC adapter supplied with the unit to this
connector to supply the DC 16 V voltage to the unit.
9
Threaded hole (thread: 1/4-20UNC) for mounting
the camera
Use this hole when mounting the camera on a tripod, etc.
:
Service switches
ON
OFF
SW1 SW2
The camera is used with all the switches at the OFF
setting.
;
IR system/service selector switch
Set this switch at the “IR” position for use.
