1
2
3
4
4
Auto Address Setting* from the Remote Controller (CZ-RTC4)
* Auto address setting in Cooling mode cannot be done from the remote controller.
NOTE
●
Selecting each refrigerant system individually for auto address setting
●
Auto address setting for each system
: Item code “A1”
1
Press the remote controller timer time
button and
button at
the same time.
(Press and hold for 4 seconds or longer.)
2
Next, press either the temperature setting
/
button. (Check
that the item code is “A1”.)
3
Use either the
button to set the system No. to perform auto
address setting.
4
Then press the
button.
(Auto address setting for one refrigerant system begins.) (When auto
address setting for one system is completed, the system returns to
normal stopped status.)
<Approximately 4 – 5 minutes is required.>
” is displayed on the remote
(During auto address setting, “
controller.
This message disappears when auto address setting is completed.)
5
Repeat the same steps to perform auto address setting for each
successive system.
Auto Address Setting from the High-spec Wired Remote Controller (CZ-RTC5A)
4
Select the “O/D unit no.” by pressing the
or
button.
Select one of the “O/D unit no.” for auto address by pressing
the
or
button.
Approximately about 10 minutes are required.
When auto address setting is completed, the units return to
normal stopped status.
[
] START
20:30 (THU)
CZ-RTC5A
CZ-RTC4
1
Keep pressing the
,
and
buttons
simultaneously for 4 or more seconds.
The “Maintenance func” screen appears on the LCD display.
2
Press the
or
button to see each menu.
If you wish to see the next screen instantly, press the
or
button.
Select “9. Auto address” on the LCD display and press the
button.
Maintenance func
0. Set elec. consumpt
10.
2. Check touch
12.
Sel.
Page [
] Confirm
20:30 (THU)
11.
1. Set touch
. Auto addre
9.
3
The “Auto address” screen appears on the LCD display.
Change the “Code no.” to “A1” by pressing the
or
button.
Auto address
Code no.
O/D unit no.
Sel.
Next
20:30 (THU)
1
A1
20-3. Auto Address Setting
Summary of Contents for GHP
Page 68: ......
