http://cxema.ru
7.6 Lock Code
NOTE:
See section 7.2.1 for a list of the equipment and setup procedures required to perform the following adjustment and
calibration procedures.
To perform the following procedures the UUT must be placed into Test Mode.
7.6.1 Check current lock code
1. (
Figure 29) At the Channel box press F4 and highlight VIEW LOCK CONDITION. Press ENTER.
Figure 29:
View lock code
600-0740
2.
The display will show the current lock status and lock code for the UUT.
7.6.2 Change current lock code
1.
At the Channel box press SHIFT and F4 and highlight PROG LOCK CONDITION. Press ENTER.
2.
(Figure 30) Press ENTER to unlock the UUT. The current lock code will be used.
Figure 30:
Program lock code
600-0741
3.
Enter “0000” to reset the UUT to factory defaults. The UUT will be locked using the lock code “0000”.
MCUK980101C8
Section 7
Issue 1
Service Manual
7 - 21
Revision 0
TEST AND MEASUREMENT
