Switch box
(Not supplied)
Front cover
Rear cover
•
Do not apply excessive force to the front cover.
•
Install the product at a height of 1 to 1.5 m from the floor.
•
Install the product vertically to the wall.
•
Leave a minimum clearance of 20 cm around the product.
•
Do not install the product where exposed to direct sunlight, heat or wind from an air conditioner.
•
Do not install the product near windows or doors.
•
Install the product in the same room as where the relevant ventilator is installed.
•
Do not put obstacles around the product.
•
Install the product at least 1 m away from TV, radio or PC.
Notice
How to Install
※
Prevent the internal cord from being bitten by the
covers.
※
Use a switch box of the right size for the
product. Refer to the external
dimensions of the product in page 4.
(Recommended size: 100 x 100 mm or
86 x 86 mm)
Rubber packing --------------------------2 pcs
Operating and Installation Instructions -----1 set
Flathead
screwdriver
Internal cord
Rear cover
Front cover
Be sure to confirm that the following attachments are enclosed in the packing box.
If anything is missing, contact our After-Sales Center or your dealer.
Ventilator remote controller ----- 1 set
Signal cord ----------------------- 10 m
Screw (M4) ----------------------- 2 pcs
1. Embed and fix a switch box in the wall.
2. Insert a flathead screwdriver into the groove at the
underside of the product to remove the rear cover,
and unplug the internal cord. (Unplug the connector
on the front cover side.)
※
Be careful not to damage the product.
※
Do not apply tension to the internal cord.
※
Cover the installation holes not used for
installation with rubber packing.
5. Reconnect the internal cord to the
front cover.
※
Attach the front cover firmly.
(A click will sound when installed correctly.)
Rear cover
Switch box
Rear cover
Signal cord
Switch box
Connector
Rear cover
Front cover
Internal cord
■
Before installation
■
How to install
4. Fix the rear cover to the switch box with screws.
(Use supplied or commercially-available screws
suitable for the switch box.)
3. Plug the signal cord into the connector on
the rear cover. (Connect the other side of
the signal cord to the relevant ventilator.)
6. Attach the front cover to the rear cover.
Screws
(supplied or
commercially-
available)
Rubber packing
3
English
※
Do not unplug this cord.
Groove
