Panasonic FP7 Series, Command Reference Manual

Page: 1209 / 1222

Code Name Operating Error contents and steps to take
129
Memory configuration
inconsistency
Continue
An inconsistency has been detected in the memory
configuration.
132
Operating history buffer
error
Continue There is an error in the operating history buffer.
133
Operating history
configuration data error
Continue
There is an error in the operating history configuration
data.
Check the operating history data settings.
134
Operating history data
error (when loading
settings from SD card)
Continue
There is an error in the operating history data saved on
the SD card.
1000
-1999
Error by ERR instruction Stop
An error as specified by ERR instruction in the user
program has occurred. Handle the error in accordance
with the specified detection conditions.
2000
-2999
Error by ERR instruction Continue
(Note 1) If an RTC data error is detected, the date is set to "April 1, 2012".
■
MEWTOCOL-COM Communication Error Codes
Code Name Description of error
!26
Abnormal unit number
setting A command was received that cannot be used globally (station number
FF).
!40 BCC error A transmission error has occurred in the received data.
!41 Format error A command was received that does not match the format.
!42 No support error An unsupported command was received.
!43
Multiple frames procedure
error Another command was received while multiple frame processing was in
progress.
!60 Parameter error The specified parameter content does not exist or cannot be used.
!61 Data error
There are errors in contact, data area, specification of data No., size
specification, range, or format specification.
!62 Registration over error
The number of registrations has been exceeded or the unit has been
operated in an unregistered state.
!63 PC mode error
A command that cannot be processed was executed in RUN mode or
while SD memory card copy was in progress.
!64
Defective external memory
error
The hardware is defective. It is likely an abnormality in the built-in ROM
(F-ROM).
The specified content exceeded the capacity during ROM transfer.
A reading/writing error has occurred.
!65 Protect error
A program or system register write operation was executed while the
device was in the protected state (password set).
!66 Address error
There is an error in the address data code format, or if the address data
was excessive or insufficient, there was an error in the range setting.
!67
No program error
and No data error
Message read and sampling trace start/read was executed on
unregistered data.
!68
Cannot write during RUN
error
While RUN was in progress, an attempt was made to edit an instruction
that cannot be rewritten (ED, SUB, RET, INT, IRET, SSTP, STPE).
Nothing can be written to the control unit.
20.3 Error Codes Table
WUME-FP7CPUPGR-12 20-21