Panasonic FP2 ET-LAN, Technical Manual

Page: 296 / 306

16-2
16.1 Sample Program
16.1.1 An Overview of the Sample Program
This is a sample program in which data is being sent and received between an ET-LAN unit and a
workstation.
System configuration
Setting conditions
Items ET-LAN unit Workstation
IP address 192.9.210.130 If the network ID is the same as
that of the ET-LAN unit, no host
ID needs to be specified.
Port No. 4097 4098
MEWTOCOL station No. 01 02
Communication function MEWTOCOL communication
PROTOCOL TCP/IP
Open method Unpassive Active (bind
→
connect)
Operation overview
After a connection has been opened, the workstation uses MEWTOCOL-COM to send data to the ET-
LAN unit, and writes it to the DT0 of the programmable controller.
On the programmable controller side, initialization processing and open processing of the ET-LAN unit
are carried out, and „01“ is set as the MEWTOCOL station number.
Usage method
1. Compile the sample program and create the execution file.
2. Enter the RUN mode on the programmable controller side.
3. Run the sample program.
4. When the connection is successfully opened, the sample program displays the following menu and
waits for input.
5. Pressing “0” at this points writes “0H” to DT0 (check this on the programmable controller side).
6. Pressing “1” at this point writes “FFFFH” to DT0 (check this on the programmable controller side).
7. Pressing “E” at this point disconnects the line and exists the program.