Panasonic FL360 - DMW - Hot-shoe clip-on Flash, Operating Instructions Manual

Page: 45 / 196

45
VQT1B11
The flash’s power does not go off
even though I turned off the power
of my digital camera which comes
with communication functions.
When the power of a digital camera
with communication functions is
switched off, the flash is set to the
power-saving mode. When the power
of the digital camera is turned back
on, the flash’s power is also turned
on.
When the flash’s power is to be
turned off, turn off its power first.
When the flash is used in
combination with a digital camera
without communication functions, it is
automatically set to the power-saving
mode when no operations have been
performed for about 15 minutes.
I can’t switch to the lighting angle.
Has the wide panel been damaged?
≥
If the wide panel is damaged while
it is extended, you will no longer be
able to use the [ZOOM] button. In
this case, you can use the [ZOOM]
button if you set wide panel
switching to [OFF].
∫
Q&A for the panel display
[ISO] and [F] are flashing or the
numbers for the ISO sensitivity
and aperture are flashing.
This means that the ISO sensitivity
and aperture of the digital camera
are outside the flash working range
of the flash.
Change the ISO sensitivity and
aperture of the digital camera.
The optimum camera to subject
distance is flashing.
The flash is too close to the subject.
If the subject is too close, the lighting
range of the flash will shift so take
photos at a distance further than
0.6 m (or 0.5 m for close-up photos).
[ ] and the lighting angle are
flashing.
Extend the wide panel.
[ ] does not go off.
The flash head has been set to point
downward (7 degrees). Do not use
this setting unless you are taking
close-ups.
[ ] does not go off.
The wide panel is extended.
≥
The guide number (GN) is
reduced.
Pay attention to the camera to
subject distance.
VQT1B11.book 45 ページ ２００６年８月３１日 木曜日 午後４時３６分