Washing
Reassembly
Humidifying filter
Wash the filter frame and filter frame cap with water.
Insert the humidifying filter into the filter frame through the splicing joint.
Attach the filter frame cap onto the filter frame.
If hard stains is hard to remove, please immerse the heavily stained filter in warm water
containing neutral detergent for kitchen purpose or in the solution of citric acid for about
30 minutes and scrub it, then wash for 2~3 times with clean water.
Do not scrub it with a brush or wash it with a washing machine.
Make sure to use the neutral detergent or solution of citric acid. If the alkaline detergent is
used, deformation and performance degeneration may be caused.
Press and wash it with clean warm
water (below
40
℃
).
1
2
Avoid any space between the filter frame cap and the filter frame of the humidifying filter,
and do not put the humidifying filter over the circular parts on the two ends. (Otherwise,
the humidifying amount may be reduced.)
MAINTENANCE
Humidifying filter assembly <about once a month
※
1
>
Do not dry it with a drier. (Doing this may cause shrinkage)
请勿用刷子刷洗或用洗衣机清洗。
请勿使用干燥机干燥。(可能导致缩小)
The proportion of citric acid and warm water is 20
g
:3 L.
As the dirtiness varies with the water quality, maintenance may be required even within one
month after the last maintenance if there is unpleasant odor or the water in the tank is reduced
in slow speed.
※
1
Anti-fungus assembly
(anti-fungus agent containing)
Immerse it in kitchen-purpose neutral
detergent solution and clean it.
Please soak it in warm water containing neutral
detergent for kitchen purpose 30 minutes, then
wash it 2~3 times with clean water.
Do not disassemble it, scrub it with a brush.
Please keep it level when installing,
and fit into the concave part of tray.
Tray
Anti-fungus assembly <about once a month
※
1
>
19
维护保养
根据水质的不同，污浊状况会有所不同，因此在清洁后
1
个月内，若气味难闻或水箱中的水减少很慢时，也应
进行清洁保养。
加湿过滤网组件
<约每月
1
次
※
1
>
清洗
加湿过滤网
水洗过滤网框架和过滤网压板。
当污渍或气味难以去除时，请将过滤网放入加有中性厨用洗涤剂或柠檬酸的温水中浸泡
30
分钟左右，
然后再用清水冲洗
2~3
次。
用清水、温水(约
40
℃
以下)进行按压清洁。
Notice
提示事项
请务必使用中性厨用洗涤剂或柠檬酸。碱性洗涤剂等可能会造成变形，导致性能下降。
柠檬酸与温水的比例为
20
g
:3 L
。
安装
从拼接处将加湿过滤网装入过滤网框架。
将过滤网压板拧在过滤网框架上，并拧紧。
确保加湿过滤网两端在过滤网框架及过滤网压板内侧，不能外露。(否则可能会导致加湿量变少)
防霉组件
<约每月
1
次
※
1
>
用加有中性厨用洗涤剂的温水进行浸泡清洗
请放入加有中性厨用洗涤剂的温水中浸泡
30
分钟左右，
然后再用清水冲洗
2~3
次。
请勿分拆清洗及勿用刷子刷洗。
安装时尽量保持水平，放入水盘的凹部。
防霉组件
(含防霉剂)
水盘
MAINTENANCE
维
护
保
养
