40
Troubleshooting
If a problem has occurred, investigate it by referring first to the table below. If the problem still
persists, please disconnect the power plug and contact an authorized service center (as
described in the warranty) for a check or repair.
Symptom
Pleasecheckthefollowing:
Thecleanindicatorremainsred
evenwhentheoperation
continues.
●
The indicator may illuminate red when the product is exposed to
steam in the bathroom or vapor emitted from sprayers.
●
When the sand is flying in the air.
●
Is the dirt sensor dirty? (P.33)
Automaticoperationcannotbe
stopped.
●
Under the setting of [Auto] or [Silent], even if the dirt is not detected,
the product will operate corresponding to the ambient humidity.
Thecleanindicatorremainsblue
evenwhentheairisdirty.
●
Is the dirt sensor dirty? (P.33)
Pollutedairisdifficulttobe
removed.
●
Is the 2 in 1 HEPA composite and deodorizing filter dirty? (P.33)
→ Clean it. If the symptom persists, replace it with the new one.
Theairvolumeissmall.
●
Is the 2 in 1 HEPA composite and deodorizing filter or the humidifying
filter dirty? (P.33, 35)
→ Clean them. If the symptom persists, replace them with the new ones.
Theodorfromtheproductis
unpleasant.
●
Is the main body, the front panel or the 2 in 1 HEPA composite and
deodorizing filter dirty?
→ Clean them. If the symptom persists, replace the 2 in 1 HEPA
composite and deodorizing filter with the new one. (P.33)
●
Is the tray or the humidifying filter dirty? (P.34, 35)
●
Is water in the tray replaced with fresh tap water every day? (P.27)
●
In "Clean air" mode (without humidifying), empty the tray.
●
Has it ever used in a room with strong smells?
If the product is used in a room where people smoke or barbecue,
a shorter replacement cycle of filters may be required. (P.33)
→ When the product is used in such environment, we recommend
that you use the ventilation system of the room simultaneously.
Thewateramountinthetray
doesnotdecrease.
Whilethehumidifyingindicator
islit,theproductdoesnot
humidify.
●
Is the humidifying filter dirty? (P.
35
)
●
Does the humidity indicator show [Hi]?
→ In the [Auto] setting, the product will stop humidifying to keep
appropriate humidity, when [Hi] is on.
●
Is the tray installed completely?
●
Is the humidifying filter installed properly? (P.35)
→ When the humidifying filter is installed incorrectly, the product will
sound abnormally, and not humidify.
Thehumiditydoesnotincrease.
●
Is the room size too large for the product?
●
Is the room ventilated or having a carpet on the floor?
→ A carpet floor or some types of ventilation and floor/wall materials
may prevent smooth humidification.
Thereiscondensationinside
thetray.
●
Immediately after the product stops operation or when the room is
cold, there may be condensation. This is normal.
Summary of Contents for F-VXL40H
Page 43: ...VXL40H 43 ...
