Please strictly follow
SETTING AND OPERATING REQUIREMENTS
Area that can enhance the effectiveness!
Way to against PM2.5 and indoor dust, etc.
Way to circulate air more effectively.
Place the product with its left, right and top about 30 cm or more away from walls, furniture or
curtains, etc, otherwise, the pollutants are difficult to be cleared.
To ensure effectiveness of this product, keep its back at least 1 cm away from the wall.
Since PM2.5, dust, etc are likely to float in the air near
the floor, we recommend you to place the product on
flat floor in the room.
CAUTION
SAFETY PRECAUTIONS
Do not sit on or lean against
this product.
(Otherwise, the product may fall over
and injury may occur or damage the
product.)
Families with children should pay more
attention.
→
Do not clean the product with
gasoline or other volatile mix-
ture solvents, and avoid con-
tacting with spray insecticides.
(Otherwise, the product may crack or
short circuit with the possibility of injury,
fire or electric shock.)
Do not operate this product in
places where indoor fumigation
type insecticides are being used.
(Chemical residue may build up inside
the product and discharge from the air
outlet, and cause damage to health.)
Ventilate the room with fresh air thor-
oughly after using insecticides before
operating the product.
→
→
Do not set the product in the
following places.
Where the product will be exposed directly to
sunlight, outlet air of air conditioner or heat, etc.
(Otherwise, deformation, degeneration,
discolor or malfunction may be occurred.)
Near equipment such as TV and radio.
(Otherwise, visual disturbances or noises may be
caused.)
Keep the product 1 m or above away from such devices.
Do not use the same power socket
with TV, radio, etc.
(Otherwise, visual disturbances or noises may
be caused.)
In this case, insert the power plug into another
power socket.
If the product is used in the same
place for a long period.
It may result in dirty surrounding walls or
floor. We recommend that you move the
product away from where it is placed when
maintaining it.
4
Do not place any object on the
product.
(Otherwise, an operation error or malfunction
may be caused.)
Do not place obstacles on the product
air inlet and outlet.
(Otherwise it may affect product performance.)
