EN
EN
- 13 -
EN
EN
4. Press the OK button to accept the new
setting.
• The control panel will stop flashing and
light up.
CAUTION:
• You must press the OK button in order
for the selected setting to take effect.
• Be sure to verify the new value after
changing the setting. (See page 15.)
Auto downshift function
• In this function, the tool starts with high
speed tightening operation and then
automatically shifts to a lower speed, 300
RPM, at the timing pre-programmed by user.
This function increases the efficiency while
not damaging materials.
1. Set the tool to setting configuration mode.
(See page 1.)
. Press the D button twice.
• The auto downshift function setting value
will be displayed.
3. Press the or buttons to change the
time as desired.
Operation
Display
Seconds
30
3 seconds
1
0.1 seconds
0
OFF
4. Press the OK button to accept the new
setting.
NOTE:
• The speed at the start of tightening
operation is set with the speed adjust-
ment function.
Cross thread reduction function
• The tool runs in reverse approximately
360° before running forward to assist in
the alignment of the threads to help reduce
cross threads.
1. Set the tool to setting configuration mode.
(See page 1.)
. Press the D button once.
• The cross thread reduction function set-
ting value will be displayed.
3. Press the or buttons to change the
setting to ON or OFF.
Display
Function
R0
OFF
R1
ON
4. Press the OK button to accept the ON or
OFF setting.
Rundown error detecting function
• In this function alerts the users that if
tightening has ended in less time than the
pre-set time by user. This function can be
used to find out rundown errors such as
retightening and cross thread.
1. Set the tool to setting configuration mode.
(See page 1.)
. Press the B button twice.
• The rundown error detecting function
setting value will be displayed.
3. Press the or buttons to change the
time as desired.
Operation
Display
Seconds
30
3 seconds
1
0.1 seconds
0
OFF
4. Press the OK button to accept the new
setting.
• When the cross thread reduction func-
tion is ON, the set time will be counted
after the tool operates in reverse for
approximately 360°.
Maintenance interval alarm function
• In this function, the tool is locked once a set
number of tightening operations has been
programmed. This function can be used
to know the regular inspection timing, for
example.
1. Set the tool to setting configuration mode.
(See page 1.)
. Press the C button twice.
• The setting value will be displayed.
3. Press the or buttons to set the
desired value.
Operation
Display Number of tightening
operations
99
990,000
1
10,000
0
OFF
Summary of Contents for EYFGA1A
Page 149: ... 149 MEMO ...
Page 150: ... 150 MEMO ...
Page 152: ...EN DE FR IT NL ES DA SV NO FI PL TR EY9711FGA101 2014 10 Printed in Japan ...