3
1.
Cautions
WARNING
●
Never use this product as a sensing device for personnel protection.
●
When using sensing devices for personnel protection, use products that meet laws
and standards, such as OSHA, ANSI or IEC etc., for personnel protection applicable in
each region or country.
●
This product has been developed / produced for industrial use only.
●
This product employs a small cable of 0.1mm
2
in conductor area. Take care that the
cable is not pulled with a strong force, as it may damage this product or break its wires.
●
Make sure that stress by forcible bend or pulling is not applied to the sensor cable joint.
●
Cable can be extended up to 50m in total length (each emitter / receiver of thru-beam
type) if extension cable is more than 0.3mm
2
in electric conductor cross-sectional area.
●
Make sure that the power supply is OFF while adding or removing the controllers.
●
Take note that incorrect wiring will damage the sensor.
●
Verify that the supply voltage variation is within the rating.
●
If power is supplied from a commercial switching regulator, ensure that the frame ground
(F.G.) terminal of the power supply is connected to an actual ground.
●
When noise generating equipment (switching regulator, inverter motor, etc.) is used in
the vicinity of this product, connect the frame ground (F.G.) terminal of the equipment to
an actual ground.
●
Do not run the wires together with high-voltage lines or power lines or put them in the
same raceway. This can cause malfunction due to induction.
● Take care that the sensor is not directly exposed to fluorescent lamp from a rapid-starter
lamp, a high frequency lighting device or sunlight etc., as it may affect the sensing per-
formance.
●
Do not use during the initial transient time (50ms) after the power supply is switched
ON.
●
This product is suitable for indoor use only.
●
Avoid dust, dirt, and steam.
●
Do not use this sensor in places where it may come in contact with corrosive gas, etc.
●
Ensure that the product does not come into contact with organic solvents such as thin-
ner.
●
Ensure that the product does not come into contact with strong acid or alkaline.
●
Ensure that the product does not come into contact with oil or grease.
●
This product cannot be used in an environment containing inflammable or explosive
gases.
●
Never disassemble or modify the product.
●
Cable end has not been waterproofed. Do not use the product in any manner that may
cause water entry via cable end.
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.clrwtr.com - Email: [email protected]
