14
Flash warning system for hypertensive readings
13
If the measured values fall within the hypertension range, the reading
displayed on screen flashes on and off to alert user.
According to JNC 7 Classification, values consistently in excess of 140 mmH
g
(Sys.) and/or 90 mmH
g
(Dia.) are considered to constitute high blood pressure.
(mmH
g
)
90
80
120 140 (mmH
g
)
Hypertension
(Stage 1, Stage 2)
Diastolic
Systolic
Prehypertension
Normal
• Blood pressure readings will flash for approx. 6 seconds when in the high
blood pressure range (Fig. 7).
Systolic blood pressure: 140 mmH
g
and over
Diastolic blood pressure:
90 mmH
g
and over
(Only when measurement is complete)
When an Error Occurs During Measurement
An
will appear on the display to indicate that measure-
ment was unsuccessful and should be performed again
(Fig. 8).
Before performing another measurement, always press the
On/Off and Start button to turn off the unit and make sure to
allow a rest period of 4 to 5 minutes before starting again.
Please consult your doctor without delay if the blood
pressure indicator repeatedly draws attention to elevated
blood pressure values.
Fig. 7
Fig. 8
Measuring Your Blood Pressure
Relax during measurements.
1. Press the On/Off and Start button (Fig. 6-a).
• All displays on the unit will light up for approx. 2
seconds (Fig. 6-b).
• The cuff will begin to inflate automatically.
Changing inflation speeds and operating sounds
occur during inflation and are a normal part of the
measurements that are being performed at this time.
2. With fingers lightly clenched to form a fist, position your
free hand beneath the arm of the wrist being measured.
• Once your pulse rate is detected, the
mark will flash
on the display (Fig. 6-c).
3. Blood pressure values together with pulse rate are
displayed when the measurement is complete (Fig. 6-d).
• The air in the pressure cuff is released automatically.
• Displayed readings will flash (for approx. 6 seconds)
when in the high blood pressure range.
• The
mark will flash on the screen to indicate that
readings may be recorded.
(See page 15 for information on how to record blood
pressure readings.)
• The displayed pulse rate indicates the number of
heartbeats per minute as calculated from the number
of heartbeats recorded during the measurement.
4. Press the On/Off and Start button to switch off the unit
(Fig. 6-e).
• If you wish to make another measurement, switch off and
wait for 4 to 5 minutes before performing another one.
• If you forget to switch the unit off, it will do so
automatically after approx. 5 minutes.
Fig. 6-a
Fig. 6-b
Fig. 6-c
Fig. 6-d
Fig. 6-e
EW3003USA̲Eng 05.1.31 11:18 ページ 13
