Installing the SFP module
8 - ENGLISH
Installing the SFP module
This section explains an example of a procedure to install and remove the SFP module. Please also check the
operating instructions and setup guide of the SFP module to be installed.
How to install the SFP module
SFP ports
Circuit boards
SFP modules
Fig. 1
1) Remove the port cover.
f
Pull out the port cover of the SFP port.
2) Install the SFP module to the SFP port. (Fig. 1)
f
With the circuit board of the SFP module visible from the top, securely insert the SFP module all the way.
f
Remove the protection cap on the <SDI OPT 1 IN> terminal, <SDI OPT 2 IN> terminal, or <SDI OPT 1/2
OUT> terminal, if there is any, before using.
Attention
f
The removed port cover and the protection cap will be needed in following cases. Store them so that they can be attached in the future.
g
When the SFP module not required anymore is removed
g
When there is a terminal not to be used
g
When storing the SFP module
How to remove the SFP module
Fig. 2
Fig. 1
SFP modules
Lever
Lever
Latch
1) Disconnect the optical fiber cable.
f
If the optical fiber cable is connected to the SFP module, remove the cable while releasing the latch of the
optical fiber cable.
2) Release the latch of the SFP module. (Fig. 1)
f
Pull up the lever on the SFP module to release the latch.
