Panasonic ET-D75LE95, Operating Instructions Manual

Page: 10 / 32

10-ENGLISH
1) Turn on the projector to start the
projection.
2) Press the <MENU> button to open
the [MAIN MENU] screen. Then select
[PROJECTOR SETUP] and press the
<ENTER> button.
3) Select [SERVICE PASSWORD] in the
[PROJECTOR SETUP] menu and press
the <ENTER> button.
4) In the [SERVICE PASSWORD] entry
screen, enter "7590" using the numeric
buttons on the remote control and then
press the <ENTER> button.
z
The [D75LE90 POSITION] screen appears.
5) Press the <ENTER> button in the [D75LE90
POSITION] screen.
z
[PROGRESS] is displayed on the [D75LE90 POSITION]
screen and lens position moves to the standard position
for the ET-D75LE95.
Note
z
When using the PT-DZ13K / PT-DS12K / PT-DW11K /
PT-DZ10K, the [MAIN VERSION] of the projector firmware
must be the version described below. Check the [MAIN
VERSION] of the firmware on the [STATUS] screen and
upgrade the firmware version of the projector as needed. *
1
Projector Main version
PT-DZ13K / PT-DS12K /
PT-DW11K / PT-DZ10K
4.04 or higher
[STATUS] screen is displayed by selecting [Main Menu]
→ [PROJECTOR SETUP] → [STATUS] or by pressing the
<STATUS> button on the remote control.
DZ13K
*1: See software download page on Panasonic website (https://panasonic.net/cns/projector/pass/). You must be a
registered PASS user to use the site described above.
PASS: Panasonic Professional Display and Projector Technical Support Website
Lens position setup and focus adjustment (continued)
Note
z
The lens position set here may not match the intended standard position exactly.
z
The lens position set with this procedure will be used as the standard position. The lens position can be
adjusted within the adjustment range described in "Adjustment range by the lens position shift (optical shift)"
(  Page 12), even after shifting to the standard position.
z
Depending on the (OSD) display position on the menu screen, there are cases where the projected light is
obstructed and a part of the menu is not displayed on the screen. In this case, open [MAIN MENU]
→
[DISPLAY
OPTIONS] → [ON-SCREEN DISPLAY] → [OSD POSITION] and change settings so that the whole OSD menu
can be seen.
● When using PT-DZ13K / PT-DS12K / PT-DW11K / PT-DZ10K