6
7
frame and rinse the inner blade/outer foil under running water or in a basin.
DO NOT USE BOILING WATER.
Next, close the outer foil frame and dry it gently. After the shaving head is
dry, place the protective cap.
Replacing shaving head components
It is recommended that you replace the outer foil at least once every year
and the inner blade at least once every two years to maintain your shaver’s
cutting performance.
Replacing the outer foil
Press the outer foil frame release buttons to remove the
outer foil frame.
Then, squeeze the front and the back side of the outer foil
frame and lift up one of the two knobs on the outer foil.
Inserting the new outer foil
Slip the foil into the frame and guide the plastic edges
onto the hooks in the outer foil frame until it clicks into
the shaver.
Replacing the inner blade
Squeeze the outer foil frame release buttons and lift the
outer foil frame upward to remove it. Remove the inner
blade by grasping it firmly at both ends and pulling
straight away from the shaver. To insert the new inner
blade, hold the blade at both ends and press downward
until it snaps into the shaver.
How to remove the built-in rechargeable
battery before disposal of shavercomponents
ATTENTION:
A nickel metal hydride battery that is recyclable powers the product you
have purchased.
Please call 1-800-8-BATTERY for information on how to recycle this
battery.
R B R C
N i - M H
T M
The battery in this shaver is not intended to be replaced by consumers.
However, the battery may be replaced at an authorized service center. The
procedure described below is intended only for removal of the rechargeable
battery for the purpose of proper disposal.
WARNING:
Do not attempt to replace the battery for the purpose of reusing the
shaver. This could result in the risk of fire or electric shock.
(f)
(h)
(g)
(e)
(c)
(d)
(j)
(i)
(k)
(l)
(m)
(a)
(b)
1
Remove four screws (a).
2
Remove two screws (b).
3
Using a flat screwdriver
(c), and insert into the
space (d) to remove the
panel (e).
4
Using a flat screwdriver
(f), and insert into the
space (g) to remove the
panel (h).
5
Pull the housing (i) out of
the end cap (j).
6
Remove two screws (k)
inside of the end cap and
pull the battery.
7
Using a flat screwdriver
(l), and insert into the
space (m) to remove the battery.
6-7
2007/10/25 15:34:13
