13
TR
RO
H
SK
CZ
PL
FIN
S
N
P
DK
E
NL
I
F
D
GB
How to use
Using the shaver
1.
Press and shave.
• The “shaving sensor”, which automatically
adjusts the power depending on the beard
thickness, will operate.
It will shave with high power on areas where
the beard is heavy, and reduce the power on
areas where the beard is thin, to reduce
burden on the skin.
• The power cannot be turned on when the switch lock
lamp ( ) blinks, as the power switch is locked.
Press the power switch for more than 2 seconds to
unlock.
(See page 14.)
Tips for better shaving
Apply the whole system outer foil
perpendicularly against the skin and
shave by slowly gliding the shaver over
the face against the grain of the beard.
• The beard under the chin and around
the throat can be shaved better by
stretching the skin so the beard will
stand.
• To prevent damaging the system outer
foil, do not shave with only a part of
the system outer foil.
Abnormal charging
The charge status lamp ( ) will blink twice every second.
Notes
• After charging is completed, turning the power switch ON
with the shaver plugged in will cause the charge status lamp
( ) to light up and then turn off after 5 seconds.
This shows that the shaver is fully charged.
• When charging the shaver for the first time or when it has
not been in use for more than 6 months, the charging time
may change or the charge status lamp ( ) may not glow for
a few minutes. It will eventually glow if kept connected.
• Recommended ambient temperature for charging is
10 °C – 35 °C. It may take longer to charge, or the charge
status lamp ( ) will blink quickly and the battery may fail to
charge properly in extremely high or low temperatures.
• The shaver can be used for approximately 2 weeks with a
full charge.
(Based on one 3-minute dry-shave usages per day in an
ambient temperature range of 20 °C – 30 °C.)
The number of usable days varies depending on the
following conditions.
- Beard thickness
- Pressure applied to the skin
- Usage frequency of the sonic vibration cleaning mode
- Use of the trimmer attachment
• If there is noise from the radio or other sources while using
or charging the appliance, move to a different location to use
the appliance.
ES‑LL21������.indb 13
2018/6/19 11:47:35
