English
Important
Before use
This clipper is designed for professional use to trim hair and
beards. Charge it for 8 hours before use for the fist time in order to
activate the built‑in rechargeable batteries. It can be operated on
either an AC adaptor or rechargeable batteries. Read all
instructions carefully before use.
Charging the clipper
Use the ER1611 hair clipper with the RE9‑39 adaptor only.
Avoid charging the batteries at temperatures below 5 °C or
above 35 °C.
Avoid charging the batteries in direct sunlight or near a radiating
heat source.
The recharge (
) lamp may blink at an early stage when it is
used for the first time or if it has not been used for 6 or more
months even if it is fully charged. This is not a malfunction.
Even though the clipper may not be used for an extended period,
charge every 6 months to preserve battery life.
The power cord cannot be replaced. If it is damaged, the AC
adaptor should be discarded.
Using the clipper
Warning ‑ Keep the appliance dry.
The clipper may become warm during operation and/or charging.
This is normal.
Check that the blades and the attachments are not damaged
before use. Replace them if they are damaged.
You should not allow permanent wave lotion, hair restorer or hair
spray to come into contact with the main body or the blades.
Doing so may result in cracking, discoloring or corrosion.
You should not drop the clipper on the floor.
You should not knock the blades and the attachments against
hard objects.
You should not trim the hair of a pet.
•
•
•
•
•
•
•
•
•
•
•
•
•
Cleaning the clipper
Clean the housing using only a cloth slightly dampened with
water or a mild soap solution.
Never use a caustic solution.
Never submerge the clipper in water.
Storing the clipper
This appliance is not intended for use by persons (including
children) with reduced physical, sensory or mental capabilities, or
lack of experience and knowledge, unless they have been given
supervision or instruction concerning use of the appliance by a
person responsible for their safety. Children should be supervised
to ensure that they do not play with the appliance.
Never tamper with moving parts.
Avoid grabbing the clipper by the power cord, as it may become
detached, causing damage or injury.
If the clipper is not working properly, have it inspected at an
authorized service center.
Specifications
Power source: See the name plate on the product.
(Automatic voltage conversion)
Motor voltage: .4 V DC
Charging time: 1 hour
Airborne Acoustical Noise: 60 (dB (A) re 1 pW)
READ ALL INSTRUCTIONS BEFORE USE.
•
•
•
•
•
•
•
Summary of Contents for ER1421
Page 43: ...98 MEMO ...
Page 44: ...99 MEMO ...