E9
English
SETTING UP THE UNIT
TO START WITH (INSTALLATION LOCATION)
Before taking the unit out of the box, decide where it is going to be set up.
Ensure that there is enough space for the unit power switch to be operated. (Approx. 10 cm of space in both the rear and on both sides)
Area where the unit and leg/foot massage section
touch the floor approx. 102 cm
Depth approx. 178 cm
(When the leg/foot massage section is raised : approx. 188 cm)
Depth approx. 157 cm
Depth approx. 150 cm
More than 10 cm
(When the backrest
is fully upright)
Width
approx. 78 cm
Mat
Keep at least 3 cm away from the wall.
(When the backrest is fully reclined)
The unit should not be used in bathrooms or
•
other damp or humid places
This may cause electric shock or the unit to
malfunction.
Use the unit on the flat area.
•
Failure to observe this precaution may result
in accidents or injuries due to the unit fallen
down.
The unit should not be used on top of heating
•
appliances, such as electric carpets, etc.
Do not operate the unit under blanket or
pillow. Excessive heating can occur and cause
fire, electric shock, or injury to persons.
Do not expose the massage lounger to direct sunlight or high temperatures, such as in front of heating sources, because this
•
can cause discoloration or hardening of the synthetic leather.
Make sure to install the unit so that the back side of the main unit does not touch the wall or any objects. (Failure to do so may
•
cause damage such as the back side deformation.)
Place the unit on a mat to prevent floor damage. When placing a mat under the unit, the size of the mat should be sufficient (at least
•
63 cm × 104 cm) to cover the areas where the unit touches and where the leg/foot massage section could touch the floor, as shown
in the diagram.
Install the unit near a power outlet.
•
1. Open the packaging and take out the unit and accessories.
Confirm that the main unit and the accessories are in the box.
Main unit
*Illustrated in the condition that it is taken out of the box.
(When the backrest is fully reclined)
Accessories
Controller Holder
Power Cord
Lock Switch Key 1 pcs.
The lock switch key has been
•
inserted in the lock switch
prior to leaving the factory.
