11
© 2015 PIONEER HOME ELECTRONICS CORPORATION.
All rights reserved.
The center speaker or rear speaker does not produce sound
Cause
Solution
AUTO SURROUND (mode that
outputs the number of input
channels as it is) is selected
upon 2-channel audio input such
as TV, music, etc.
To play a stereo sound source in multichannel, press the
SURR
button or the
ADV
button to select your favorite
mode.
Example) Press the
SURR
button several times to select
[
EXT.STEREO
].
The subwoofer does not produce sound
Cause
Solution
The front speaker is set to
LARGE.
(The low frequency component
will be produced from the front
speaker instead of the subwoofer
when 2-channel audio input such
as TV, music, etc.)
To produce output from the subwoofer, change the
speaker setting. (There are two ways.)
Method 1
Change the front speaker to SMALL.
• The low frequency component will be produced from
the subwoofer instead of the front speaker. When
the front speaker has a high capability to play low
frequency components, we recommend not to change.
Method 2
Change the subwoofer to PLUS.
• The low frequency component of the front speaker
will be produced from both the front speaker and the
subwoofer. Therefore, the bass sound may be too
powerful. In that case, we recommend not to change or
to change using Method 1.
For the procedure to change, refer to the “Speaker Setting”
in the CD-ROM’s operating instructions.
HDMI, network, etc. operations become unresponsive
Cause
Solution
The operations of this
receiver and connecting
devices are unresponsive.
Try resetting. To reset, turn off the power, and press down the
STANDBY/ON
button on the front panel for 5 seconds or more.
(The power turns off in 5 seconds after the power is turned on.
The receiver’s setting will be maintained.)
Also try replugging the power cord of the connecting devices.
To produce sound from TV
Refer to page 8 of the booklet to perform connection and setting.
To play, press the
TV
button to switch to TV input.
The remote control does not work
Cause
Solution
The operation mode of
the remote control is not
switched.
When operating the receiver
• Start the operation after pressing the
MAIN RECEIVER
button.
To operate functions such as network and iPod
• Start the operation after pressing the button of each function
(
NET
,
iPod
, etc.).
• If still not working, press the
MAIN RECEIVER
button first and
then press the button of each function.
2 TVs (projector) are connected but video and audio are sometimes
interrupted or not produced
Cause
Solution
They may be interrupted or
not produced when affected
by the TV in power standby.
Press the
OUT P.
button and
/
button so that HDMI
output connected with that TV is not selected. Refer to
“Switching the HDMI output” in the CD-ROM’s operating
instructions for details.
The power suddenly turns off and the WIRELESS indicator flashes
Cause
Solution
The core wire of the
speaker cord is touching
the rear panel, or touching
other core wires, and the
protection circuit is active.
Twist the conductive wire of the speaker cord once again, and
connect it so that it will not stick out from the speaker terminal
on the amplifier or speaker side.
Frequently asked questions
