OPERATING INSTRUCTIONS
MCUK010801C8
Section 3
Issue 1
Service Manual
– 7 –
Revision 0
3.7.Incoming Call Line Identification (CLI)
When a call is received the last six digits of the CLI information is matched with the phonebook. Therefore an incoming call
could be matched to the wrong phonebook entry.
3.8.
Hot Key Dial Source List
The source for Hot Key Dial Numbers is normally ‘Phonebook’ or ‘Service Dial Numbers’. For some OEMs it may be a
requirement to store these numbers in Flash-ROM. When the source is the Flash-ROM and the telephone software is
updated, the source numbers may be lost. Also, if the user changes the source of the Hot Key Dial numbers, it will not be
possible to redirect the source back to Flash-ROM. However, in the event that an OEM would like the Hot Key Dial source to
be stored in the Flash-ROM, it is unlikely that the user will have the option to change the Hot Key Dial source.
3.9.
Public Man Machine Interface (MMI)
3.9.1
General
It is possible to operate all GSM telephones in the same way using the Public MMI. The following operations will work with all
GSM telephones. However, this information is restricted to those operations supported by the telephone.
The * and # in the following procedures should be replaced by
and
respectively. Also <SND> and <END> should be
replaced with
and
keys.
3.9.2
Reading the Phonebook Memory Location
# <MEMORY LOCATION>
Leading zeros can be left out of the location number, e.g. 007 can be 7.
3.9.3
Presentation of IMEI
* # 0 6 #
3.9.4
Security
3.9.5
Call Hold
3.9.6
Call Waiting
Change PIN
* * 0 4 * <OLD PIN> * <NEW PIN> * <NEW PIN> #
Change PIN2
* * 0 4 2 * <OLD PIN2> * <NEW PIN2> * <NEW PIN2> #
Unblock PIN
* * 0 5 * <PIN UNBLOCKING KEY> * <NEW PIN> * <NEW PIN> #
Unblock PIN2
* * 0 5 * <PIN2 UNBLOCKING KEY> * <NEW PIN2> * <NEW PIN2> #
Place a Call on Hold
2 <SND>
Recall a Held Call
2 <SND>
Make a Second Call
<TELEPHONE NUMBER> <SND>
Swap between two Held Calls
2 <SND>
End Held Call
0 <SND>
End Active Call
1 <SND>
Reject Incoming Call
0 <SND>
Enable Call Waiting
* 4 3 * <SND>
Disable Call Waiting
# 4 3 * <SND>
Call Waiting Status
* # 4 3 * # <SND>
Summary of Contents for EB-GD95
Page 64: ...LAYOUT DIAGRAMS MCUK010801C8 Section 9 Issue 1 Service Manual 60 Revision 0 D C E A B F 3 4 ...
Page 66: ...CIRCUIT DIAGRAMS on 9 Issue 1 Revision 0 GD95 Circuit Diagram Logic A4 A4 ...
Page 67: ...CIRCUIT DIAGRAMS Issue 1 Section 9 Revision 0 58 Figure 9 2 GD95 Cir A4 A4 ...
Page 68: ...9 MCUK010801C8 Service Manual GD95 Circuit Diagram RF A4 A4 EB GD95 EBGD95C ...
