Panasonic DP-MB310EU, Service Manual

Page: 124 / 538

124
KX-MB2230EU/ KX-MB2270EU/ KX-MB2515EU/ KX-MB2545EU/ KX-MB2575EU/ DP-MB310EU
Note:
•
Do not place the unit in an area where the document sub tray may be easily bumped into.
• Confirm that there are no documents on the scanner glass.
• Confirm that any ink, paste or correction fluid has dried completely.
• Remove clips, staples or other fasteners.
• Do not insert the following types of documents (Make a copy of the document using the scanner glass and set the copy instead.):
- Chemically treated paper such as carbon or carbonless duplicating paper
- Electrostatically charged paper
- Badly curled, creased or torn paper
- Paper with a coated surface
- Paper with printing on the opposite side that can be seen through the other side, such as newsprint
• When feeding certain types of document (for example, if back of the page is not clean) through the automatic document feeder, it
is possible that dirty marks may be left on the original document. To prevent this, we recommend feeding the document one page
at a time when using the automatic document feeder, or to use the scanner glass.
• The total height of the documents when laid flat, must be less than 7mm. If the documents exceed the capacity of the automatic
document feeder, they may fall or cause a jam in the feeder.
• To set a document with a width of less than 210 mm, we recommend using the scanner glass to copy the original document onto
A4 or letter-size paper, then setting the copied document for better results.
• Do not set documents that do not satisfy the requirements of size and weight. Make a copy of the document using the scanner
glass and set the copy.
• Available document size, document weight and effective scanning area are as follows:
• Shaded area will be scanned.
• For 2-sided scanning, the minimum document size is 148 mm
×
210 mm.
• For 2-sided scanning, the maximum document size is 216 mm
×
356 mm.
• When using the unit as a scanner, the effective scanning
length depends on the selected paper size.
3.
• For A6 size documents, always insert the document in portrait
direction (insert long edge into the feeder).
• Adjust the width of the document guides (1) to fit the actual size of
the document.