Panasonic DP-MB310EU, Service Manual

Page: 173 / 538

173
KX-MB2230EU/ KX-MB2270EU/ KX-MB2515EU/ KX-MB2545EU/ KX-MB2575EU/ DP-MB310EU
• The other party’s fax machine is busy or has run out of recording paper. Try again.
• The document is jammed. Remove the jammed document.
• Attempted to send or copy a document longer than 600 mm using the automatic document feeder.
Remove the document, and then press [Stop] to clear the message. Divide the document into two or more
sheets and try again.
• The ADF top cover is not fully closed. Push firmly on the front and rear edges of the ADF top cover, and
then feed the document again.
• Recording paper is installed in the manual tray when trying to receive faxes or print reports. Remove the
recording paper from the manual tray.
• The memory is full of received documents due to a lack of recording paper or a recording paper jam. Load
paper or remove the jammed paper.
• If the PC fax (feature #442) is set to “ALWAYS”,
- check the connection between the computer and the unit.
- check that the computer is turned ON.
• If the fax preview mode (feature #448) is set to “ON“.
- view, print or save the received fax documents using the web browser on the computer connected via
the LAN, and then erase the unnecessary documents.
- turn the setting to “OFF“. The fax documents stored in memory will be printed automatically.
Refer to
Program Mode Table (P.177).
• After the unit has been in power save mode (feature #403) for up to 5 minutes, the unit will enter sleep
mode. Press any key to put the unit in standby for the next process.
Note:
• The unit may not enter sleep mode when beeping for alert or displaying an error message.
• The toner is empty. Replace the toner cartridge immediately.
• The toner life is near to an end. Replace the toner cartridge as soon as possible.
• The toner cartridge has finished its service life. Replace the toner cartridge immediately.
• The toner is reaching the end of its life. You will need to replace the toner cartridge soon.
• A transmission error occurred. Try again.
• The USB memory device was removed while being accessed for reading/writing. Insert the device and
reperform the operation.
• A fault occurred while the USB memory device was being accessed for reading/writing. Using a computer,
check that the device can be read and written to normally.
• There is no space to save new data on the USB memory device. Erase unnecessary data using your com-
puter.
• When performing scan to USB memory, the total number of scanned pages is exceeded the limitation.
Divide the document into sections.
• The media is unformatted or is formatted to an unsupported format (e.g., NTFS). Using a computer, format
to FAT32. Formatting deletes all data on the USB memory device. Make sure to back up your data before
formatting.
• An unsupported USB memory device is connected. Devices with particular security features or hub fea-
tures cannot be used.
• The USB memory device has been removed from the unit. Reinsert it.
• There is no USB memory device inserted in the unit. Insert one.
• The write-protection switch of the USB memory device is in the lock position. Unlock the switch to allow
writing access.
• The saving folder in the USB memory device is set to “read only”. Using a computer, set the saving folder
to “writable”. (For details about the saving folder name specifications.)
DISPLAY MESSAGE CAUSE AND REMEDY