Panasonic DMR-UBS80EG, Service Manual

Page: 40 / 93

40
U76 HDMI connection error HDMI cannot be output because you are
connected to a model that does not support
copyright protection. No display
U77 Illegal disc error Due to the current disc not having
authorized copyright information, video
output is not performed. No display
U88 The unit is carrying out its
recovery process.
(with a disc in the disc tray) • The unit detected an error while
recording or playing with a disc in the
disc tray. The unit is carrying out its
recovery process. This process restores
the unit to normal operation. The unit is
not broken.
Wait until the message disappears.
No display
U99 Hang-up Displayed when communication error has
occurred between Main microprocessor
and Timer microprocessor. No display
Displayed is left until the [POWER]
key is pressed.
H19 02 Inoperative fan motor When inoperative fan motor is detected
after powered on, the power is turned off
automatically.
The event is saved in memory. No display No display
F00 No error information Initial setting for error code in memory
(Error code Initialization is possible with
error code initialization and main unit
initialization.) No display No display
F34 Initialization error when main
microprocessor is started up
for program recording When initialization error is detected after
starting up main microprocessor for
program recording, the power is turned off
automatically.
The event is saved in memory. No display No display
F58 Drive hardware error When drive unit error is detected, the event
is saved in memory. No display No display
F74 HDMI Device Key
Communication error. HDMI connection could not be
authenticated due to a transfer malfunction.
Factor of HDMI Device key-road failure
• When HDMI LSI is damaged.
• When the bus line of I2C doesn't
operate normally.
• When device key information recorded
is damaged.
No display
F75 HDMI Device Key Information
error HDMI connection could not be
authenticated due to an internal data
malfunction.
Factor of HDMI Device key-road failure
• When HDMI LSI is damaged.
• When the bus line of I2C doesn't
operate normally.
• When device key information recorded
is damaged.
No display
SET
CODE * Remote control code error Display appears when main unit and
remote controller codes are not matched. No display
"*" is remote controller code of the
main unit.
Display for 5 seconds.
UNSUPPO
RT Unsupported disc error *An unsupported format disc was played,
although the drive starts normally.
*The data format is not supported, although
the media type is supported.
*Exceptionally in case of the disc is dirty. "This disc is
incompatible." Display for 5 seconds.
NO READ Disc read error *A disc is flawed or dirty.
*A poor quality failed to start.
*The track information could not be read. "Cannot read.
Please check the
disc."
Error Code Diagnosis contents Description Monitor Display Automatic FL display