Setup
TQBS0149
86
4K(50p/60p) Output
This unit automatically chooses to output
images in 4K (50p/60p) when connected to a
4K (50p or 60p) compatible TV.
• This item is available only when “Video
Format” is set to “Automatic” or “4K”.
• Images will not be output correctly with an
HDMI cable that does not support 18 Gbps.
• To connect to a TV that supports 4K
(50p/60p) 4:4:4/8 bit or 4K (50p/60p)
4:2:2/12 bit, select “4K(50p/60p) 4:4:4”.
• To connect to a TV that supports 4K
(50p/60p) 4:2:0/8 bit, select “4K(50p/60p)
4:2:0”.
24p Output
When playing BD-Video recorded in
24 frames, this unit displays each frame at
1/24 second intervals–the same interval
originally shot with the film movie.
• When this unit is connected to TV
compatible with 4K/24p and “Video Format”
is set to “Automatic”, images will be output
in 4K/24p.
• When this unit is connected to a TV
compatible with 1080/24p and “Video
Format” is set to “Automatic”, “1080i” or
“1080p”, images will be output in 1080/24p.
• When BD-Video images other than 24p are played,
images are output at 60p.
• This unit cannot output 4K image when playing back in
3D.
Advanced Settings
Press [OK] to show the following settings:
Colour Mode
This setting is for selecting colour-space
conversion of the image signal.
Deep Colour Output
Set the output method to be used when
this unit is connected to a TV that
supports Deep Colour.
HDR (High Dynamic Range) Output
Output images in HDR (High Dynamic
Range) format depending on the content
and connected TV.
HLG / PQ Conversion
Set whether or not to convert HDR (High
Dynamic Range) videos in HLG format to
PQ format before outputting them when
this unit is connected to a TV that
supports only HDR (PQ) format.
• When “HDR (High Dynamic Range)
Output” is set to “Off”, this setting is
disabled.
Audio Output
Select “Off” when connected to an
amplifier/receiver with a DIGITAL AUDIO
OUT terminal.
Contents Type Flag
If “Automatic” is selected, the optimal
method of playback depending on the TV
(e.g. cinema) will automatically be
selected (only when the TV supports
Contents Type Flag).
Common Interface
Access to software contained on CI module.
(
>
9)
• Select “Slot 1:” or “Slot 2:” and press [OK].
Follow the on-screen instructions.
• On-screen instructions may not correspond to the remote
control buttons.
• For more information about TV service, please contact
your service provider.
• Depending on the card, in some cases its use together
with this unit may be limited or not possible.
DMR-UBC86EN_eng.book 86 ページ ２０１７年８月８日 火曜日 午前１１時１２分
