Panasonic DMC-FX07EB, Service Manual

Page: 24 / 50

24
8.3.8. Removal of the Sub P.C.B.
Fig. D9
8.3.9. Removal of the Battery Case
Fig. D10
NOTE: (When Assembling)
Be sure to confirm the following points when assembling.
• The Screw is tightened enough.
• Assembling conditions are fine. (No distortion, no illegal-
space.)
• No dust and/or dirt on every Lens surfaces.
• LCD image is fine. (No dust and dirt on it, and no gradient
images.)
8.4. Disassembly Procedure for the
Lens
NOTE: When Disassembling and Assembling for the Lens
1. To minimize the possibility of the CCD being dirt, perform
disassemble and/or assemble under the condition of the
CCD is being mounted.
Disassembling procedures for the CCD unit, refer to item
8.6.
2. Take care that the dust and dirt are not entered into the
lens.
In case of the dust is putted on the lens, blow off them by
airbrush.
3. Do not touch the surface of lens.
4. Use lens cleaning KIT (BK)(VFK1900BK).
5. Apply the grease (VFK1829) to the point where is shown
to" Grease apply" in the figure.
When the grease is applied, use a toothpick and apply
thinly.
8.4.1. Zoom Motor Unit, Master Frange
Unit, Drive/Direct Frame Unit and
1st Lens Frame/2nd Lens Frame
Move Unit
1. Unscrew the 4 screws (A).
2. Remove the zoom motor unit to the indicated by arrow.
3. Remove the master frange unit to the indicated by arrow.