- 5 -
Connect DVD Recorder and TV set to
the AC mains socket.
You can connect the DVD Recorder to your
TV set by using a RF cable (Aerial cable).
2
Follow the steps below.
3
1
Connect aerial to the RF IN (Aerial
input) connector of the DVD Recorder.
Connect the DVD Recorder´s RF OUT
(Aerial output) to the TV set’s Aerial in
connector.
Disconnect the power from all units.
Follow the steps for Auto-Setup on this
page.
Connecting with RF cable (Aerial cable)
= Extra equipment for the connection shown:
RF cable (aerial cable)
Since optimal picture quality cannot be achieved, the
connection with the RF cable is not recommended.
DVD Recorder
1
2
3
TV
Aerial
AC mains lead
RF IN
Aerial input
AV1 21-pin
Scart socket
RF cable
Aerial
input
RF OUT
Aerial output
Aerial
infeed line
AC IN~
3
AC mains lead
HDD/DVD OUT
Auto-Setup with RF cable (Aerial cable)
(Automatic tuning)
!
Turn on your television set.
!
With the
Standby/on switch
turn on the DVD Recorder. Automatic tuning for all
available TV stations begins. Approximate duration is 5 minutes.
- While Auto-Setup is running, the first digit of the DVD Recorder display will flash. After
a while it will stop flashing and the RF output channel number will be displayed.
- Select an unused channel pre-set on your TV and tune it to the RF output channel
number shown on the DVD Recorder display (or until you can clearly see the Auto-
Setup screen). Store the new RF output channel (refer to the instructions for your TV).
In some cases, the RF output channel may interfere with the TV stations transmitted in
your area. This may prevent you from seeing the On-Screen Display clearly. Please
see page 24
for removing the interference before restarting
Auto-Setup (page 97
).
of Operating Instructions
of Operating Instructions
You can complete the Owner ID now or skip this step and do it later. To do it later, press
the
RETURN
button. Your DVD Recorder is now ready to use.
!
To set the Owner ID now, use and press the
Numeric
buttons or
to enter a
four-digit PIN number. Press , to correct the digit.
!
Be sure to remember the PIN number (write it down).
!
Press the
ENTER
button twice to confirm.
!
Enter the [Name], [House No] and [Postcode] in the same way, using
.
!
Press the
ENTER
button to confirm each entry.
!
Press the
RETURN
button to leave the Owner ID screen.
!
You will now see the TV picture. Your DVD Recorder is now ready to use.
Owner ID
!
Press
to set the correct time and date and press
ENTER
to finish this setting.
If the clock setting menu appears
(Auto clock set was not possible due to a weak signal)
Mind that a wrong date or time will influence the programmed recording of TV
programmes (don't forget to change summer time and winter time).
DVD Display
Clock
Off
Automatic
0
00
00
1
1
2005
:
:
.
.
Time
Date
CHANGE
ENTER
RETURN
Clock cannot be set automatically.
Please set the clock manually.
ENTER: store RETURN: leave
SELECT
0
9
No
Auto-Setup
Ch
4
Suche Sender, bitte warten.
RETURN: abbrechen
35
Auto-Setup in progress, please wait.
RETURN: to abort
RETURN
Owner ID
RETURN
Name
House No.
Postcode
PIN number
* * * *
RETURN : leave
!
After Automatic tuning has finished, the Owner ID screen will appear.
E
E