24
Removing interference / Changing RF output channel
In some cases, interference (lines or patterning) or a very poor picture may appear on
the TV when the DVD Recorder is connected. If this happens, follow the steps below to
change the RF output channel to remove the interference.
!
Press the
FUNCTIONS
button for more than 5 seconds. The RF output channel
number is displayed on the DVD display.
!
Press
ENTER
to finish this setting.
!
Press the
Numeric
buttons or use the Channel
(CH)
button to select a
channel number, which differs at least by 2 or 3 from the present channel
number. (For example, if the original channel number was 28, enter 31.)
21
68
(RF OFF)
...
!
Retune your TV until you receive the Test pattern. It may be necessary
to repeat steps above until you can see the Test pattern clearly.
If using a Scart cable please see the note below.
!
Press
for about 5 seconds. The preset channel will be displayed on the
DVD display.
!
Press channel select buttons
CH
or
0
to invoke [- -].
!
Confirm with
ENTER
.
FUNCTIONS
Set the RF output channel of the DVD Recorder to [- -] (RF OFF) if the DVD Recorder is
connected to the TV via the 21-pin Scart cable.
TV screen
The picture with interference
On-Screen Display
Test pattern indication
The clear picture
DVD display
Indication when the RF output
channel is 21 (example)
Indication after changing the RF
output channel to 31 (example)
Test pattern indication
SELECT
ENTER
RETURN
RF OUTPUT CHANNEL
CH:
21
DVD
SELECT
ENTER
RETURN
RF OUTPUT CHANNEL
CH:
31
DVD
CH
1
2
3
4
5
6
7
8
9
0
FU
NC
TIO
N
S
!
Select
HDD
or
DVD
.
HDD
DVD
