71
RQT9075
Operation
Page
Cannot operate the television.
The remote control doesn’t work.
≥
Change the manufacturer code. Some televisions cannot be operated even if you change the
code.
≥
The remote control and main unit are using different codes. Change the code on the remote
control.
Press and hold [OK] and the indicated number button at the same time
for more than 5 seconds.
≥
The batteries are depleted. Replace them with new ones.
≥
You are not pointing the remote control at the main unit’s remote control signal sensor during
operation.
≥
Coloured glass may obstruct the signal reception/transmission.
≥
Don’t place the signal sensor in direct sunlight or in areas that may be subject to sunlight
exposure.
≥
It may be necessary to set the code on the remote control again after changing the batteries.
≥
It may be necessary to set the manufacturer code again after changing the batteries.
≥
The child lock function is activated.
62
61
4
4
—
—
61
62
62
The unit is on but cannot be
operated.
≥
Recording drive or playback drive has not been selected properly.
≥
Some operations may be prohibited by the disc.
≥
The unit is hot (“U59” appears on the display). Wait for “U59” to disappear.
≥
One of the unit’s safety devices may have been activated.
Reset the unit as follows:
1 Press [
Í
/I] on the main unit to switch the unit to standby.
If the unit doesn’t switch to standby, press and hold [
Í
/I] on the main unit for about
10 seconds. The unit is forcibly switched to standby.
Alternatively, disconnect the AC mains lead, wait one minute, then reconnect it.
2 Press [
Í
/I] on the main unit to switch it on. If the unit still cannot be operated, consult the
dealer.
16, 17
—
—
—
Cannot eject disc.
≥
The unit is recording.
≥
The unit may have a problem. While the unit is off, press and hold [
∫
] and [CH
W
]
on the
main unit at the same time for about 5 seconds. Remove the disc and consult the dealer.
If the Child Lock function is activated, above operation does not work. Cancel the Child Lock
function.
—
62
Cannot tune channels.
Cannot download channel
presets from the television.
≥
Check the connections.
≥
You must connect to a VIERA Link (HDAVI Control 3) compatible TV with a HDMI cable to
download channel presets.
8, 65
—
Startup is slow.
≥
Make sure that “Quick Start” is set to “On”.
≥
Startup takes time in the following situations:
– A disc other than a DVD-RAM is inserted.
– The clock is not set.
– Immediately after a power failure or the AC mains lead is connected.
– For a few minutes after 5:15 am due to system maintenance of this unit.
– When the unit is connected with an HDMI cable.
61
—
T
roub
le
s
hoot
ing guide
DMREH58&68GN_RQT9075-L_eng.book 71 ページ ２００８年２月２９日 金曜日 午前１１時４０分
